BRUSHCUTTER TRI CUT BLADE 14 INCH HEAVY DUTY AIRECUT 350
AIRECUT 350 HEAVY DUTY TRI CUT BLADE
SUITS Over 30cc TRIMMER
350mm (14 inch)
25mm (1 inch) CENTER HOLE
COMES WITH REDUCING WASHER FOR 20mm CENTER HOLE
THIS BLADE HAS A UNIQUE AIRFOIL TWIST THAT
CREATES A STRONG UPWARD AIRFLOW WHICH
CARRIES THE MATERIAL AWAY FROM THE CUTTING AREA
The Tri-blade tip has a reversed bevel like a chisel.
The bottom of the bevel is parallel to the ground so the cut
stalks fiber acts as an emery board which continually sharpens the base.
This keeps the blade sharp with minimal filing.
The reversible Airecut Tri-Blade doubles the lifespan of usage.
AIRECUT BLADES ARE FOR SERIOUS BRUSHCUTTING
AND WILL CUT THROUGH UP TO 1 1/2 INCH
PLEASE USE SAFETY EQUIPMENT INCLUDING
|Unit Of Measure||ea|
Like a hot knife through butterBy: Darren Lay on 30 November 2017I first bought an Airecut 250 (10 inch) and have used it to slash any tough weeds, bracken fern, blackberries, saplings etc on my acreage. These blades are not a toy and would cause some serious damage if you're not careful. I recently bought the Airecut 350 to make my job a bit easier and it slashes through tough growth with even more ease. I couldn't be happier with these blades' ability to get the job done properly. You will end up a bit covered in pieces of grass or whatever you cut due to the way it's thrown up and away from the blade - nothing that a good brush off won't fix. Highly recommended for serious slashing but be careful where you point it as shed walls and water tanks and pipes will be shredded...not from experience, just basic commonsense.